1. Product introduction:
The magnetic filter iron remover is mainly used to separate the fine iron filings in the liquid medium to meet the technological requirements of the liquid medium. It is widely used in chemical, pharmaceutical, pigment, dyestuff, food, metallurgy, ceramics and other industries. This product has the advantages of strong magnetic force, good iron removal effect and convenient iron cleaning.
2. Working principle:
When the liquid of the magnetic filter enters the box through the main pipe, when the medium contains fine iron filings, it will be adsorbed on the magnetic rod, and the clean fluid will be discharged from the outlet of the filter. When cleaning is needed, the screw plug of the drain outlet at the bottom of the main pipe can be unscrewed to drain the fluid, the flange cover can be removed, the magnetic rod can be taken out for cleaning, and then it can be re installed. It can filter the rust, sand in the sewage and a small amount of solid particles in the liquid, so as to protect the fittings on the equipment pipeline from abrasion and blockage, and protect the normal operation of the equipment.
3. Product features:
1. Permanent Nd-Fe-B magnetic rod is used, and the surface magnetism can reach 12000gs.
2. It has the advantages of strong magnetic force, good iron removal effect and convenient cleaning of iron filings.
3. It can remove 0.5 ~ 60 μ M small particles that cannot be seen by the naked eye.
4. The surface finish of bar magnetic steel can meet the requirements of food grade.
5. Its magnetic source is made of high-performance Nd-Fe-B permanent magnetic material, and its magnetic force is 5-20 times higher than that of similar conventional magnetic materials (ferrite or alnico permanent magnetic material).
4. Installation and maintenance of iron remover:
1. The flange interface of the magnetic filter is connected with the flange circuit of the slurry output pipe to make the slurry flow through the filter evenly. After a period of trial, the cleaning cycle is determined.
2. When cleaning, loosen the clamping screw on the cover, and then pull out the magnetic rod to clean the iron impurities adsorbed on the magnetic rod. After cleaning, install the magnetic rod, tighten the clamping screw, and then tighten the cover of the magnetic rod to continue to use.
3. When cleaning, the extracted magnetic rod cover shall not be placed on the metal object to prevent damage to the magnetic rod.